EPeS screw coupling for 4mm hose (external thread M5)

<p>Choosing the <strong>right size and type of <a href=”https://kamaradsvyhodami.cz/en/dictionary/hpa” target=”_blank”>HPA</a> connector</strong> can be challenging, so before purchasing the connector, check the following information about your HPA setup to choose the correct type of connector based on its usage:</p>
<ul>
<li><strong>diameter of your supply hose</strong> (4mm, 6mm)</li>
<li><strong>thread</strong> (M5, M6, 1/8 NTP)</li>
<li><strong>thread type</strong> (external, internal)</li>
<li><strong>hose end type (<a href=”https://kamaradsvyhodami.cz/en/dictionary/qd” target=”_blank”>QD</a></strong> FOSTER, QD EU, push-in, etc.)</li>
</ul>

<p><strong>EPeS will make your life easier again</strong> because it has prepared <strong>endings of all possible types</strong> precisely for your supply hose/regulator.<br />For easier installation, it is recommended to heat the hose before fitting (applies to crimping), and the working pressure of the connectors corresponds to standard pressures of HPA system up to <strong>300psi.</strong></p>